Review of Aluminia 80
Basic specs.
If you have a photo you would like to share: Upload Image
Looking for a new boat? Find a Aluminia 80 or similar boat for sale
The boat can enter most marinas as the draft is just about 1.60 - 1.70 meter (5.25 - 5.55 ft) dependent on the load. See immersion rate below.
Aluminia 80 is typically equipped with an engine.
Sailing characteristics
This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.
What is Capsize Screening Formula (CSF)?
The capsize screening value for Aluminia 80 is 2.31, indicating that this boat would not be accepted to participate in ocean races.
The immersion rate is defined as the weight required to sink the boat a certain level.
The immersion rate for Aluminia 80 is about 134 kg/cm, alternatively 750 lbs/inch.
Meaning: if you load 134 kg cargo on the boat then it will sink 1 cm.
Alternatively, if you load 750 lbs cargo on the boat it will sink 1 inch.
Sailing statistics
This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.
What is L/B (Length Beam Ratio)?
The l/b ratio for Aluminia 80 is 3.20.
SA/D (Sail Area Displacement ratio)
Indicates how fast the boat is in light wind:
- Cruising Boats have ratios 10-15
- Cruiser-Racers have ratios 16-20
- Racers have ratios above 20
- High-Performance Racers have ratios above 24
Sail-area/displacement ratio (SA/D ratio): 21.34
Maintenance
If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.
| Usage | Length | Diameter | ||
| Jib sheet | 8.0 m | (26.2 feet) | 10 mm | (3/8 inch) |
| Genoa sheet | 8.0 m | (26.2 feet) | 10 mm | (3/8 inch) |
| Mainsheet | 20.0 m | (65.6 feet) | 10 mm | (3/8 inch) |
| Spinnaker sheet | 17.6 m | (57.7 feet) | 10 mm | (3/8 inch) |
This section is reserved boat owner's changes, improvements, etc. Here you might find (or contribute with) inspiration for your boat.
Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.
We are always looking for new photos. If you can contribute with photos for Aluminia 80 it would be a great help.
If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.