Review of Centurion 40

Basic specs.

The Centurion 40 is a large sailboat designed by the French maritime architect Edward George Dubois in the late eighties. Less than 100 boats have been produced. The Centurion 40 is built by the French yard Wauquiez.

Here we would have liked to show you nice photos of the Centurion 40.
If you have a photo you would like to share: Upload Image

Looking for a new boat? Find a Centurion 40 or similar boat for sale

Hull

The hull is made of fibreglass. Generally, a hull made of fibreglass requires only a minimum of maintenance during the sailing season.

Rig

The boat equipped with a masthead rig. The advantage of a masthead rig is its simplicity and the fact that a given sail area - compared with a fractional rig - can be carried lower and thus with less heeling moment.

Keel

The Centurion 40 is equipped with a fin keel. A boat with a fin keel is more manoeuvrable but has less directional stability than a similar boat with a long keel.

The keel is made of lead. Compared with iron, lead has the advantage of being 44% heavier, which allows a smaller keel and hence less water resistance and higher speed.

The boat can only enter major marinas as the draft is about 2.35 - 2.45 meter (7.71 - 8.01 ft) dependent on the load. See immersion rate below.

Engine

The boat is typically equipped with an engine.

Sailing characteristics

This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.

Immersion rate

The immersion rate is defined as the weight required to sink the boat a certain level. The immersion rate for Centurion 40 is about 330 kg/cm, alternatively 1850 lbs/inch.
Meaning: if you load 330 kg cargo on the boat then it will sink 1 cm. Alternatively, if you load 1850 lbs cargo on the boat it will sink 1 inch.

Sailing statistics

This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.

L/B (Length Beam Ratio)

What is L/B (Length Beam Ratio)?

The l/b ratio for Centurion 40 is 2.95.

Compared with other similar sailboats it is more spacy than 82% of all other designs. It seems that the designer has chosen a significantly more spacy hull design.

Ballast Ratio

What is a Ballast Ratio?

The ballast ratio for Centurion 40 is 37%.

This ballast ratio shows a righting moment that is higher than 38% of all similar sailboat designs. A righting moment (ability to resist heeling) just below average.

Over- / underrigged

The Centurion 40 has more rig than 12% of all similar sailboats, which indicates that the boat is significantly underrigged.

Maintenance

Rig

Dimensions of sail for masthead rig.

Are your sails worn out? You might find your next sail here: Sails for Sale

If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.

**Guiding dimensions of running rig**
Usage	Length		Diameter
Mainsail halyard	31.9 m	(104.7 feet)	12 mm	(1/2 inch)
Jib/genoa halyard	31.9 m	(104.7 feet)	12 mm	(1/2 inch)
Spinnaker halyard	31.9 m	(104.7 feet)	12 mm	(1/2 inch)
Jib sheet	12.1 m	(39.6 feet)	14 mm	(0.55 inch)
Genoa sheet	12.1 m	(39.6 feet)	14 mm	(0.55 inch)
Mainsheet	30.2 m	(98.9 feet)	14 mm	(0.55 inch)
Spinnaker sheet	26.5 m	(87.0 feet)	14 mm	(0.55 inch)
Cunningham	3.9 m	(12.8 feet)	12 mm	(1/2 inch)
Kickingstrap	7.8 m	(25.6 feet)	12 mm	(1/2 inch)
Clew-outhaul	7.8 m	(25.6 feet)	12 mm	(1/2 inch)

Boat owner's ideas

This section is reserved boat owner's changes, improvements, etc. Here you might find (or contribute with) inspiration for your boat.

Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.

Finally

We are always looking for new photos. If you can contribute with photos for Centurion 40 it would be a great help.

If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.

References

[Ref 1]: ISO 8666 Small craft — Principal data.
[Ref 3]: ISO 12215-5 Small craft — Hull construction and scantlings.