Review of Ecume de Mer 26

Basic specs.

The Ecume de Mer 26 is a sailboat designed by the French maritime architect Jean-Marie Finot in the early seventies. The Ecume de Mer 26 is built by the French yard Chantier Mallard.

Here we would have liked to show you nice photos of the Ecume de Mer 26.
If you have a photo you would like to share: Upload Image

Looking for a new boat? Find a Ecume de Mer 26 or similar boat for sale

Interior

The boat is equipped with 5 berths and toilet facility.

Keel

The boat can enter most marinas as the draft is just about 1.65 - 1.75 meter (5.41 - 5.71 ft) dependent on the load. See immersion rate below.

Engine

Ecume de Mer 26 is typically equipped with an engine.

Sailing characteristics

This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.

Immersion rate

The immersion rate is defined as the weight required to sink the boat a certain level. The immersion rate for Ecume de Mer 26 is about 140 kg/cm, alternatively 785 lbs/inch.
Meaning: if you load 140 kg cargo on the boat then it will sink 1 cm. Alternatively, if you load 785 lbs cargo on the boat it will sink 1 inch.

Sailing statistics

This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.

L/B (Length Beam Ratio)

What is L/B (Length Beam Ratio)?

The l/b ratio for Ecume de Mer 26 is 2.98.

Compared with other similar sailboats it is more spacy than 54% of all other designs. It seems that the designer has chosen a slightly more spacy hull design.

RSP (Relative Speed Performance)

What is Relative Speed Performance?

The Relative Speed Performance for Ecume de Mer 26 is 46

The relative speed performance is 46 which means that a it is faster than 46% of all similar sailboat designs.

Maintenance

Rig

If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.

**Guiding dimensions of running rig**
Usage	Length		Diameter
Jib sheet	7.9 m	(25.9 feet)	10 mm	(3/8 inch)
Genoa sheet	7.9 m	(25.9 feet)	10 mm	(3/8 inch)
Mainsheet	19.8 m	(64.8 feet)	10 mm	(3/8 inch)
Spinnaker sheet	17.4 m	(57.0 feet)	10 mm	(3/8 inch)

Boat owner's ideas

This section is reserved boat owner's changes, improvements, etc. Here you might find (or contribute with) inspiration for your boat.

Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.

Finally

We are always looking for new photos. If you can contribute with photos for Ecume de Mer 26 it would be a great help.

If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.

References

[Ref 1]: ISO 8666 Small craft — Principal data.
[Ref 3]: ISO 12215-5 Small craft — Hull construction and scantlings.