Review of Alberg 23

Basic specs.

sail specifications
The Alberg 23 aka Sea Sprite 23 Weekender is a small sailboat designed by the Swedish maritime architect Carl Alberg in the early seventies. The Alberg 23 is built by the American yard C. E. Ryder.

Here we would have liked to show you nice photos of the Alberg 23.
If you have a photo you would like to share: Upload Image

Looking for a new boat? Find a Alberg 23 or similar boat for sale


The hull is made of fibreglass. Generally, a hull made of fibreglass requires only a minimum of maintenance during the sailing season. And outside the sailing season, just bottom cleaning and perhaps anti-fouling painting once a year - a few hours of work, that's all.


The boat equipped with a fractional rig. A fractional rig has smaller headsails which make tacking easier, which is an advantage for cruisers and racers, of course. The downside is that having the wind from behind often requires a genaker or a spinnaker for optimal speed.


The Alberg 23 is equipped with a long keel. A long keel provide a better directional stability than a similar boat with a fin keel; on the other hand, better directional stability means also that the boat is more difficult to handle in a harbour with less space.

The boat can enter even shallow marinas as the draft is just about 0.94 - 1.04 meter (3.08 - 3.38 ft) dependent on the load. See immersion rate below.

Sailing characteristics

This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.

Stability and Safety

What is Capsize Screening Formula (CSF)?

The capsize screening value for Alberg 23 is 1.87, indicating that this boat could - if evaluated by this formula alone - be accepted to participate in ocean races.

Theoretical Maximum Hull Speed

What is Theoretical Maximum Hull Speed?

The theoretical maximal speed of a displacement boat of this length is 5.4 knots. The term "Theoretical Maximum Hull Speed" is widely used even though a boat can sail faster. The term shall be interpreted as above the theoretical speed a great additional power is necessary for a small gain in speed.

Immersion rate

The immersion rate is defined as the weight required to sink the boat a certain level. The immersion rate for Alberg 23 is about 70 kg/cm, alternatively 395 lbs/inch.
Meaning: if you load 70 kg cargo on the boat then it will sink 1 cm. Alternatively, if you load 395 lbs cargo on the boat it will sink 1 inch.

Sailing statistics

This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.

Motion Comfort Ratio

What is Motion Comfort Ratio (MCR)?

The Motion Comfort Ratio for Alberg 23 is 21.3.

Low High 90% 0 50 100
Comparing this ratio with similar sailboats show that it is more comfortable than 90% of all similar sailboat designs. This is a comfort value significantly above average.

L/B (Length Beam Ratio)

What is L/B (Length Beam Ratio)?

The l/b ratio for Alberg 23 is 3.22.

Wide Slim 86% 0 50 100
Compared with other similar sailboats it is slimmer than 86% of all other designs. It seems that the designer has chosen a significantly more speedy hull design.

Ballast Ratio

What is a Ballast Ratio?

The ballast ratio for Alberg 23 is 41%.

Low High 58% 0 50 100
This ballast ratio shows a righting moment that is higher than 58% of all similar sailboat designs. A righting moment (ability to resist heeling) just above average.

D/L (Displacement Length Ratio)

What is Displacement Length Ratio?

The DL-ratio for Alberg 23 is 349 which categorizes this boat among 'heavy cruisers'.

Heavy Light 3% 0 50 100
3% of all similar sailboat designs are categorized as heavier. A heavy displacement combined with smaller water plane area has lower acceleration and is more comfortable.

SA/D (Sail Area Displacement ratio)

What is SA/D (Sail Area Displacement ratio)?

The SA/D for Alberg 23 with ISO 8666 reference sail is 17.8, with a 135% genua the SA/D is 20.2.

Low High 50% 0 50 100
The SA/D ratio indicates that it is faster than 50% of all similar sailboat designs in light wind.

Over- / underrigged

Low High 90% 0 50 100
The Alberg 23 has more rig than 90% of all similar sailboats, which indicates that the boat is significantly overrigged.


Bottom Paint

When buying anti-fouling bottom paint, it's nice to know how much to buy. The surface of the wet bottom is about 8m2 (86 ft2).
Based on this, your favourite maritime shop can tell you the quantity you need.

Note: If you use a paint roller you will need more paint than if you use a paintbrush.


Dimensions of sail for fractional rig.

mainsail specifications headsail specifications

Are your sails worn out? You might find your next sail here: Sails for Sale

If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.

Guiding dimensions of running rig
Mainsail halyard 21.9 m(71.8 feet)8 mm(5/16 inch)
Jib/genoa halyard21.9 m(71.8 feet)8 mm(5/16 inch)
Spinnaker halyard21.9 m(71.8 feet)8 mm(5/16 inch)
Jib sheet 6.9 m(22.5 feet)10 mm(3/8 inch)
Genoa sheet6.9 m(22.5 feet)10 mm(3/8 inch)
Mainsheet 17.2 m(56.3 feet)10 mm(3/8 inch)
Spinnaker sheet15.1 m(49.5 feet)10 mm(3/8 inch)
Cunningham3.5 m(11.4 feet)8 mm(5/16 inch)
Kickingstrap7.0 m(22.8 feet)8 mm(5/16 inch)
Clew-outhaul7.0 m(22.8 feet)8 mm(5/16 inch)

Boat owner's ideas

This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.

Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.


We are always looking for new photos. If you can contribute with photos for Alberg 23 it would be a great help.

If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.