Review of C&C 44
Basic specs.
Looking for a new boat? Find a C&C 44 or similar boat for sale
The C&C 44 has been built with more than one type of keel.
One option is a fin keel. A boat with a fin keel is more manoeuvrable but has less directional stability than a similar boat with a long keel.
Another option is a centerboard keel. A centerboard keel is a pivoting lifting keel, allowing to sail both coastal and inland waters.
The boat can only enter major marinas as the draft is about 2.12 - 2.22 meter (6.96 - 7.26 ft) dependent on the load. See immersion rate below.
The boat is typically equipped with an engine.
Sailing characteristics
This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.
The immersion rate is defined as the weight required to sink the boat a certain level.
The immersion rate for C&C 44 is about 363 kg/cm, alternatively 2037 lbs/inch.
Meaning: if you load 363 kg cargo on the boat then it will sink 1 cm.
Alternatively, if you load 2037 lbs cargo on the boat it will sink 1 inch.
Sailing statistics
This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.
What is L/B (Length Beam Ratio)?
The l/b ratio for C&C 44 is 3.31.
Maintenance
Dimensions of sail.
Are your sails worn out? You might find your next sail here: Sails for Sale
If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.
| Usage | Length | Diameter | ||
| Mainsail halyard | 40.7 m | (133.5 feet) | 14 mm | (0.55 inch) |
| Jib/genoa halyard | 40.7 m | (133.5 feet) | 14 mm | (0.55 inch) |
| Spinnaker halyard | 40.7 m | (133.5 feet) | 14 mm | (0.55 inch) |
| Jib sheet | 13.4 m | (44.0 feet) | 16 mm | (5/8 inch) |
| Genoa sheet | 13.4 m | (44.0 feet) | 16 mm | (5/8 inch) |
| Mainsheet | 33.5 m | (110.0 feet) | 16 mm | (5/8 inch) |
| Spinnaker sheet | 29.5 m | (96.8 feet) | 16 mm | (5/8 inch) |
| Cunningham | 4.8 m | (15.7 feet) | 14 mm | (0.55 inch) |
| Kickingstrap | 9.6 m | (31.4 feet) | 14 mm | (0.55 inch) |
| Clew-outhaul | 9.6 m | (31.4 feet) | 14 mm | (0.55 inch) |
This section is reserved boat owner's changes, improvements, etc. Here you might find (or contribute with) inspiration for your boat.
Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.
We are always looking for new photos. If you can contribute with photos for C&C 44 it would be a great help.
If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.