Review of Hallberg-Rassy Misil I

Basic specs.

The Hallberg-Rassy Misil I aka Misil I is a small motorsailer designed by the Swedish maritime architect Olle Enderlein in the mid sixties. A few hundred boats have been produced.

Here we would have liked to show you nice photos of the Hallberg-Rassy Misil I.
If you have a photo you would like to share: Upload Image

Looking for a new boat? Find a Hallberg-Rassy Misil I or similar boat for sale

Engine

The boat is typically equipped with an engine.

Sailing characteristics

This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.

Stability and Safety

What is Capsize Screening Formula (CSF)?

The capsize screening value for Hallberg-Rassy Misil I is 1.91, indicating that this boat could - if evaluated by this formula alone - be accepted to participate in ocean races.

Theoretical Maximum Hull Speed

What is Theoretical Maximum Hull Speed?

The theoretical maximal speed of a displacement boat of this length is 6.0 knots. The term "Theoretical Maximum Hull Speed" is widely used even though a boat can sail faster. The term shall be interpreted as above the theoretical speed a great additional power is necessary for a small gain in speed.

Immersion rate

The immersion rate is defined as the weight required to sink the boat a certain level. The immersion rate for Hallberg-Rassy Misil I is about 93 kg/cm, alternatively 522 lbs/inch.
Meaning: if you load 93 kg cargo on the boat then it will sink 1 cm. Alternatively, if you load 522 lbs cargo on the boat it will sink 1 inch.

Sailing statistics

This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.

Motion Comfort Ratio

What is Motion Comfort Ratio (MCR)?

The Motion Comfort Ratio for Hallberg-Rassy Misil I is 19.5.

Comparing this ratio with similar sailboats show that it is more comfortable than 69% of all similar sailboat designs. This comfort value is just above average.

L/B (Length Beam Ratio)

What is L/B (Length Beam Ratio)?

The l/b ratio for Hallberg-Rassy Misil I is 3.20.

Compared with other similar sailboats it is slimmer than 79% of all other designs. It seems that the designer has chosen a significantly more speedy hull design.

D/L (Displacement Length Ratio)

What is Displacement Length Ratio?

The DL-ratio for Hallberg-Rassy Misil I is 226 which categorizes this boat among 'light crusers & offshore racers'.

46% of all similar sailboat designs are categorized as heavier. A heavy displacement combined with smaller water plane area has lower acceleration and is more comfortable.

SA/D (Sail Area Displacement ratio)

What is SA/D (Sail Area Displacement ratio)?

The SA/D for Hallberg-Rassy Misil I with ISO 8666 reference sail is 14.3, with a 135% genua the SA/D is 16.8.

The SA/D ratio indicates that it is faster than 24% of all similar sailboat designs in light wind.
Don't panic! It is expected that motor sailers has a low SA/D value as this is the natural consequence of the design combining sailing and motor boat characteristics.

RSP (Relative Speed Performance)

What is Relative Speed Performance?

The Relative Speed Performance for Hallberg-Rassy Misil I is 24

The relative speed performance is 24 which means that a it is faster than 24% of all similar sailboat designs. As this boat is a motor sailer, it is expected that the performance of a motor sailer for sail alone is lower than a dedicated sailboat.

Maintenance

Rig

Dimensions of sail.

Are your sails worn out? You might find your next sail here: Sails for Sale

If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.

**Guiding dimensions of running rig**
Usage	Length		Diameter
Mainsail halyard	18.8 m	(61.7 feet)	8 mm	(5/16 inch)
Jib/genoa halyard	18.8 m	(61.7 feet)	8 mm	(5/16 inch)
Spinnaker halyard	18.8 m	(61.7 feet)	8 mm	(5/16 inch)
Jib sheet	7.3 m	(24.1 feet)	10 mm	(3/8 inch)
Genoa sheet	7.3 m	(24.1 feet)	10 mm	(3/8 inch)
Mainsheet	18.4 m	(60.3 feet)	10 mm	(3/8 inch)
Spinnaker sheet	16.2 m	(53.1 feet)	10 mm	(3/8 inch)
Cunningham	2.9 m	(9.4 feet)	8 mm	(5/16 inch)
Kickingstrap	5.8 m	(18.9 feet)	8 mm	(5/16 inch)
Clew-outhaul	5.8 m	(18.9 feet)	8 mm	(5/16 inch)

Boat owner's ideas

This section shown boat owner's changes, improvements, etc. Here you might find inspiration for your boat.

Do you have changes/improvements you would like to share? Upload a photo and describe what to look for.

Finally

We are always looking for new photos. If you can contribute with photos for Hallberg-Rassy Misil I it would be a great help.

If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.

References

[Ref 1]: ISO 8666 Small craft — Principal data.
[Ref 3]: ISO 12215-5 Small craft — Hull construction and scantlings.