Review of Amazon 44
Basic specs.
If you have a photo you would like to share: Upload Image
Looking for a new boat? Find an Amazon 44 or similar boat for sale
The boat is equipped with a galley and toilet facility.
The interior is like most other boats made of teak. Teak has the advantage of being naturally very oily and therefore water-repellent, which is suitable on boats.
The Amazon 44 is built with a cutter rig. A cutter rig breaks the yacht’s sail area down into smaller, easier to manage sails. Cutter rigs are often used for offshore sailing.
Fin keel
The Amazon 44 is built with a fin keel. The fin keel is the most common keel and provides splendid manoeuvrability. The downside is that it has less directional stability than a long keel.
The boat can only enter major marinas as the draft is about 1.83 - 1.93 meter (6.00 - 6.30 ft) dependent on the load. See immersion rate below.
The fuel tank has a capacity of 1078 liters (284 US gallons, 237 imperial gallons).
Amazon 44 may be equipped with an inboard Yanmar 4JH-DTE diesel engine at 77 hp (57 kW). Cruise speed is 6.0 knots.
The transmission is a shaft drive. A shaft drive will in the long run require less maintenance than other types of drive e.g. a sail drive.
Sailing characteristics
This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.
What is Capsize Screening Formula (CSF)?
The capsize screening value for Amazon 44 is 1.75, indicating that this boat could - if evaluated by this formula alone - be accepted to participate in ocean races.
What is Theoretical Maximum Hull Speed?
The theoretical maximal speed of a displacement boat of this length is 8.1 knots. The term "Theoretical Maximum Hull Speed" is widely used even though a boat can sail faster. The term shall be interpreted as above the theoretical speed a great additional power is necessary for a small gain in speed.
The immersion rate is defined as the weight required to sink the boat a certain level.
The immersion rate for Amazon 44 is about 312 kg/cm, alternatively 1752 lbs/inch.
Meaning: if you load 312 kg cargo on the boat then it will sink 1 cm.
Alternatively, if you load 1752 lbs cargo on the boat it will sink 1 inch.
Sailing statistics
This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.
What is Motion Comfort Ratio (MCR)?
The Motion Comfort Ratio for Amazon 44 is 36.8.
What is L/B (Length Beam Ratio)?
The l/b ratio for Amazon 44 is 3.22.
What is Displacement Length Ratio?
The DL-ratio for Amazon 44 is 273 which categorizes this boat among 'light crusers & offshore racers'.
Maintenance
When buying anti-fouling bottom paint, it's nice to know how much to buy.
The surface of the wet bottom is about 50m2 (538 ft2).
Based on this, your favourite maritime shop can tell you the quantity you need.
Note: If you use a paint roller you will need more paint than if you use a paintbrush.
If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.
| Usage | Length | Diameter | ||
| Jib sheet | 13.4 m | (44.0 feet) | 16 mm | (5/8 inch) |
| Genoa sheet | 13.4 m | (44.0 feet) | 16 mm | (5/8 inch) |
| Mainsheet | 33.5 m | (110.0 feet) | 16 mm | (5/8 inch) |
| Spinnaker sheet | 29.5 m | (96.8 feet) | 16 mm | (5/8 inch) |
This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.
Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.
We are always looking for new photos. If you can contribute with photos for Amazon 44 it would be a great help.
If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.