Review of Princess 435

Basic specs.

The Princess 435 is a large motorboat designed by the maritime architect Bernard Olesinski in the late eighties. The Princess 435 is built by the British yard Marine Projects.

Here we would have liked to show you nice photos of the Princess 435.
If you have a photo you would like to share: Upload Image

Looking for a new boat? Find a Princess 435 or similar boat for sale

Hull

Both the hull and the deck is made of hand laid fibreglass. Generally, a hull made of hand laid fibreglass requires only a minimum of maintenance during the sailing season.
The hull is a double hull which improves the indoor climate. Especially when the water is colder than the air in the cabin, then the double hull insulates against cold water and reduce the condense water in the cabin.
The deck is a double deck which improves the indoor climate.

Interior

The interior is like most other boats made of teak. Teak has the advantage of being naturally very oily and therefore water-repellent, which is suitable on boats.
The boat is equipped with 3 cabins, 8 berths, a galley and toilet facility.

Engine

The boat is typically equipped with dual inboard Volvo Penta engines at 612.0 hp (455 kW).

The transmission is a shaft drive.

The fuel tank which is made of stainless steel has a capacity of 1364 liters (360 US gallons, 300 imperial gallons).

Sailing characteristics

This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.

Immersion rate

The immersion rate is defined as the weight required to sink the boat a certain level. The immersion rate for Princess 435 is about 355 kg/cm, alternatively 1992 lbs/inch.
Meaning: if you load 355 kg cargo on the boat then it will sink 1 cm. Alternatively, if you load 1992 lbs cargo on the boat it will sink 1 inch.

Sailing statistics

This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.

L/B (Length Beam Ratio)

What is L/B (Length Beam Ratio)?

The l/b ratio for Princess 435 is 3.34.

Compared with other similar motor boats it is slimmer than 54% of all other designs. It seems that the designer has chosen a slightly more speedy hull design.

Curiosities

Powerboat?

In Denmark, you are required to have achieved a 'powerboat driving license' in order to sail a powerboat.
In this context a boat is considered a powerboat if:

Danish definition of a powerboat

According to this definition this boat is categorized as a Powerboat.

Maintenance

Boat owner's ideas

This section is reserved boat owner's changes, improvements, etc. Here you might find (or contribute with) inspiration for your boat.

Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.

Finally

We are always looking for new photos. If you can contribute with photos for Princess 435 it would be a great help.

If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.

References

[Ref 1]: ISO 8666 Small craft — Principal data.
[Ref 3]: ISO 12215-5 Small craft — Hull construction and scantlings.