Review of Triss Norlin

Triss Norlin anno 1978.

Basic specs.

The Triss Norlin is a small sailboat designed by the Swedish maritime architect Peter Norlin in the late seventies. A few hundred boats have been produced.

Looking for a new boat? Find a Triss Norlin or similar boat for sale

Rig

The boat equipped with a fractional rig. A fractional rig has smaller headsails which make tacking easier, which is an advantage for cruisers and racers, of course. The downside is that having the wind from behind often requires a genaker or a spinnaker for optimal speed.

Engine

The boat is typically equipped with an engine.

Sailing characteristics

This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.

Stability and Safety

What is Capsize Screening Formula (CSF)?

The capsize screening value for Triss Norlin is 2.33, indicating that this boat would not be accepted to participate in ocean races.

Theoretical Maximum Hull Speed

What is Theoretical Maximum Hull Speed?

The theoretical maximal speed of a displacement boat of this length is 5.3 knots. The term "Theoretical Maximum Hull Speed" is widely used even though a boat can sail faster. The term shall be interpreted as above the theoretical speed a great additional power is necessary for a small gain in speed.

Immersion rate

The immersion rate is defined as the weight required to sink the boat a certain level. The immersion rate for Triss Norlin is about 71 kg/cm, alternatively 401 lbs/inch.
Meaning: if you load 71 kg cargo on the boat then it will sink 1 cm. Alternatively, if you load 401 lbs cargo on the boat it will sink 1 inch.

Sailing statistics

This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.

Motion Comfort Ratio

What is Motion Comfort Ratio (MCR)?

The Motion Comfort Ratio for Triss Norlin is 12.9.

Comparing this ratio with similar sailboats show that it is more comfortable than 66% of all similar sailboat designs. This comfort value is just above average.

L/B (Length Beam Ratio)

What is L/B (Length Beam Ratio)?

The l/b ratio for Triss Norlin is 2.58.

Compared with other similar sailboats it is more spacy than 62% of all other designs. It seems that the designer has chosen a slightly more spacy hull design.

D/L (Displacement Length Ratio)

What is Displacement Length Ratio?

The DL-ratio for Triss Norlin is 226 which categorizes this boat among 'light crusers & offshore racers'.

24% of all similar sailboat designs are categorized as heavier. A heavy displacement combined with smaller water plane area has lower acceleration and is more comfortable.

SA/D (Sail Area Displacement ratio)

What is SA/D (Sail Area Displacement ratio)?

The SA/D for Triss Norlin with ISO 8666 reference sail is 15.7, with a 135% genua the SA/D is 18.2.

The SA/D ratio indicates that it is faster than 27% of all similar sailboat designs in light wind.

RSP (Relative Speed Performance)

What is Relative Speed Performance?

The Relative Speed Performance for Triss Norlin is 27

The relative speed performance is 27 which means that a it is faster than 27% of all similar sailboat designs.

Maintenance

Rig

Dimensions of sail for fractional rig.

Are your sails worn out? You might find your next sail here: Sails for Sale

If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.

**Guiding dimensions of running rig**
Usage	Length		Diameter
Mainsail halyard	18.1 m	(59.2 feet)	6 mm	(1/4 inch)
Jib/genoa halyard	18.1 m	(59.2 feet)	6 mm	(1/4 inch)
Spinnaker halyard	18.1 m	(59.2 feet)	6 mm	(1/4 inch)
Jib sheet	5.8 m	(18.9 feet)	8 mm	(5/16 inch)
Genoa sheet	5.8 m	(18.9 feet)	8 mm	(5/16 inch)
Mainsheet	14.4 m	(47.2 feet)	8 mm	(5/16 inch)
Spinnaker sheet	12.7 m	(41.5 feet)	8 mm	(5/16 inch)
Cunningham	2.4 m	(7.7 feet)	6 mm	(1/4 inch)
Kickingstrap	4.7 m	(15.4 feet)	6 mm	(1/4 inch)
Clew-outhaul	4.7 m	(15.4 feet)	6 mm	(1/4 inch)

Boat owner's ideas

This section is reserved boat owner's changes, improvements, etc. Here you might find (or contribute with) inspiration for your boat.

Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.

Finally

We are always looking for new photos. If you can contribute with photos for Triss Norlin it would be a great help.

If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.

References

[Ref 1]: ISO 8666 Small craft — Principal data.
[Ref 3]: ISO 12215-5 Small craft — Hull construction and scantlings.